![]() I left the tablet to charge the battery for at LEAST 3 hours. Nothing else was happening but I could see the LG logo. It turns out that the battery had no power.Īfter a few minutes the LG logo appeared on the screen. I disconnected the tablet from the PC and I plugged in the wall charger. It was like refreshing itself every 5 seconds or so. Nothing was detected, or so I thought, because I could see that in Device Manager something was happening. After that I disconnected and reconnected the tablet to the PC. But the files were already written on the tablet.ħ. Click the START button again.Īfter performing the checks you should see that the files from the image (aboot.mbn, boot.mbn, etc.) are written to the tablet.Īfter that, the BoardDiag tried to reset the tablet, but it failed and it ended with FAIL for SDRAM under the Test Results section. The other settings were already made in step 5. Now you will also check the SDRAM TEST checkbox on the left top side of the BoardDiag application. Now we will Flash the files to the tablet. If everything is OK you should see under the Test Results section the green text PASS both under the AP and EMMC. Now Click on the big START button and wait for the checks to be made. These settings are in the top-right side of the BoardDiag application. Select as the Target Dir the folder where you extracted the. Choose the Com Port that you took a note of at step 2. Now select the AP check and EMMC TEST checkboxes from the Board Diag Test section on the top-left.Īlso choose the G-pro (APQ8064) on the AP Chipset dropdown selection box. ![]() Now we will perform some cheks on the tablet. button next to DIR and browse to a folder to extract the files in.Ĭlick on the Extract button and wait for the files to be extracted.Īfter the extraction is complete, close the BoardDiag application.ĥ. button next to BIN from the Image Extraction section on the bottom of the BoardDiag application and browse to the. Unrar the archive and open BoardDiag3.99c application.Ĭlick on the. For the other versions I always got some error:ĭevice not found in dload trying flash programmer I have tried other versions and this was the only one that worked. Please use only this one even if you have another BoardDiag. Hxxp://mega.nz/#!XwgkXTAR!JnAAXKBQoezT7CcxRSVkSQlPFr4AXcvfm6oJbw4 bht4 I have used the one from here (LG G Pad 8.3 V500 4.4.2): Reconnect the tablet and you should now see the device as Qualcomm HS-USB QDLoader 9008 (COMxx) under the Ports section in Device Manager.ģ. I have used the driver from the "checked" folder. Hxxp://mega.nz/#!HlpViaTJ!NPACjSQtTjGWdYIj3kHO3bGfmAotaSSQindmgRY 9VJ4 Install the QHSUSB Driver for your operating system. ![]() The device should be seen as QHSUSB_DLOAD in Other Devices section in Device Manager.Ģ. First of all you should make sure that the G Pad is detected when connected to the PC. Note 2: The same process should also work on LG G Pad 10.1 (With a different. Note 1: The operating system on my PC is Windows XP SP3 x86 This is the process that I used to unbrick the LG G Pad 8.3 tablet. Unbricking LG G Pad in QHSUSB_DLOAD mode - G Pad 8.3 Q&A, Help & Troubleshooting Hello
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |